Technics OTTAVA f SC-C70MK2 User Manual

31
(Continued)
Wireless LAN connection
■
Preparation
Disconnect the AC power supply cord.
Disconnect the LAN cable.
Place this unit as close to the wireless router as
possible.
Connect the AC power supply cord to this unit.
(⇒ 27)
Note
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• To cancel this setting in the middle, press [
] or
turn the unit to standby mode.
• When the connection is established, “
” is
displayed.
Network setting for the first time using
the “Google Home” app
1 Press [ ] to turn this unit on.
• “Wi-Fi Setup” is displayed.
2 Press [ ], [ ] to select “Yes” and then
press [OK].
3 Start the “Google Home” app and
follow the on-screen instructions. (⇒ 32)
Note
• This unit will be displayed as “Technics-SC-
C70MK2-
****
” if the device name is not set.
(“
****
” stands for characters unique to each set.)
• You can check your network information (SSID,
MAC address and IP address) from the “Google
Home” app or “Technics Audio Center” app.
• Some items on the “Google Home” app are
irrelevant to this unit.
• When this unit is switched to standby mode and
turned on before the Wi-Fi setting is complete,
“Wi-Fi Setup” is displayed. Set “Wi-Fi Menu” to
“Off” to turn off the display.

Technics OTTAVA f SC-C70MK2 Specifications

General

CD Player	Yes
Bluetooth	Yes
Bluetooth Version	4.2
Bluetooth Codec	SBC, AAC
Bluetooth Profiles	A2DP, AVRCP
USB Playback	Yes
Optical Input	Yes
Ethernet	Yes
Headphone Output	Yes
JENO Engine	Yes
LAPC (Load Adaptive Phase Calibration)	Yes
Impedance	6Ω
Power Supply	AC 220-240V, 50Hz/60Hz
Power Consumption	38W
Speaker Units	Tweeter: 2cm Dome Type x2, Woofer: 8cm Cone Type x2, Subwoofer: 12cm Cone Type x1
Wi-Fi	Yes
Streaming Services	Spotify, TIDAL, Deezer, Internet Radio
Multi-Room	Yes
Type	All-in-one stereo system