Technics OTTAVA f SC-C70MK2 User Manual

22
(Continued)
Using the remote control
2
1
R03/LR03, AAA
(Alkaline or manganese batteries)
Note
• Insert the battery so the terminals ( and )
match those in the remote control.
• Point it at the remote control signal sensor on this
unit. (⇒ 16)
• Keep the batteries out of reach of children to
prevent swallowing.
Remote control mode
When other equipment responds to the supplied
remote control, change the remote control mode.
• The factory default is “Mode 1”.
1 Press [SETUP].
2 Press [
], [ ] to select “Remote
Control” and then press [OK].
• The current remote control mode of this unit is
displayed.
3 When “Set Mode 1/2” is displayed,
change the remote control mode of the
remote control.
To set “Mode 1”:
Press and hold [OK] and [1] for at least
4 seconds.
To set “Mode 2”:
Press and hold [OK] and [2] for at least
4 seconds.
4 Point the remote control at this unit,
and press and hold [OK] for at least
4 seconds.
• When the remote control mode is changed, the
new mode will appear on the display for a few
seconds.

Technics OTTAVA f SC-C70MK2 Specifications

General

CD Player	Yes
Bluetooth	Yes
Bluetooth Version	4.2
Bluetooth Codec	SBC, AAC
Bluetooth Profiles	A2DP, AVRCP
USB Playback	Yes
Optical Input	Yes
Ethernet	Yes
Headphone Output	Yes
JENO Engine	Yes
LAPC (Load Adaptive Phase Calibration)	Yes
Impedance	6Ω
Power Supply	AC 220-240V, 50Hz/60Hz
Power Consumption	38W
Speaker Units	Tweeter: 2cm Dome Type x2, Woofer: 8cm Cone Type x2, Subwoofer: 12cm Cone Type x1
Wi-Fi	Yes
Streaming Services	Spotify, TIDAL, Deezer, Internet Radio
Multi-Room	Yes
Type	All-in-one stereo system