95
(Continued)
Network
Cannot connect to the network.
• Confirm the network connection and settings.
(⇒ 28)
• If the network is set to be invisible, make the
network visible while you set up the network for
this unit or make a wired LAN connection.
• This system’s Wi-Fi security supports WPA2™.
Your wireless router must therefore be WPA2™
compatible. For details on the security supported
by your router and how to change the settings,
please refer to the operating instructions or
contact your internet service provider.
• Make sure that the multicast function on the
wireless router is enabled.
• The wireless LAN environment or radio
interference in your area may cause connection
problem. In this case, try another connection
method. If the problem persists, make a wired
LAN connection. (⇒ 30)
• While the AC power supply cord is disconnected,
the LAN cable must be connected or
disconnected.
Cannot select this system as the output
speakers.
• Make sure that the devices are connected to the
same network as this unit.
• Reconnect the devices to the network.
• Turn the wireless router off and then on.
• Turn this unit to standby and on, and then select
this system as the output speakers again.
To Next Page
Loading...
Need help?
General
