13
(Continued)
Adjusting with the Space Tune function
• You can adjust the sound quality automatically
according to the installation location (near the
wall or the corner of the room). Press and hold
[SETUP] ([-SPACE TUNE AUTO]) to start the sound
adjustment.
• The auto adjustment function is not available while
the headphone is connected.
• A test tone outputs quite big while the
measurement is in progress.
• To cancel the adjustment in the middle, press [
].
• When the adjustment is complete, “Success” is
displayed.
• You can also start the adjustment by pressing
and holding [
] on the unit for 5 seconds.
Press [ ] again while “Space Tune (Auto)” is
displayed.
Unit care
• Pull out the AC power supply cord from the socket
before maintenance. Clean this unit with a soft
cloth. To clean the top panel of this unit, use a soft
cloth such as cleaning cloth (optional), etc. and
wipe it horizontally along its texture.
• When dirt is heavy, wring a wet cloth tightly to
wipe the dirt, and then wipe it with a soft cloth.
• Do not use solvents including benzine, thinner,
alcohol, kitchen detergent, chemical wiper, etc.
Doing so may cause the exterior case to be
deformed or the coating to come off.
To Next Page
Loading...
