Technidea ZIPLEVEL PRO-2000 User Manual

6) Pack up the ZIPLEVEL
®
when not in use for extended periods of time.
Never leave out in foul weather or overnight. Avoid storage inside a hot
closed vehicle or trunk.
7) ZIPLEVEL
®
contains a non-toxic biodegradable clear liquid. In the un-
likely event that a damaged unit releases liquid or if the Cord is cut, bend
over Cord and wrap with tape or wire to stop liquid release. Wipe up liquid
with absorbent towels, remove residue with soap and water and return to
factory for service.
35 ▪ ZIPLEVEL CARE TROUBLE SHOOTING ▪ 36
See page 30 for alarm indicators
Problem Action
Replace battery Unit won’t turn on or shuts off
soon after turn on
Display shows 8888 with steady
tone even though elevation is
small
Unit is stuck in an undesired func-
tion and you can’t remember how
to escape
Check for Cord kink or damage.
Initialize (see page 25)
Initialize and don’t forget to re-
calibrate
Cord ashes on display and/or
readings are not repeatable
Check Cord and Base Unit and
return to factory for 3 year interval
recharge and/or repair if damaged
ErrX ashes on display when unit
is switch on
Return to factory – unit may need
service

Technidea ZIPLEVEL PRO-2000 Specifications

Ranges

set-up vertical range	40’ (12m)
set-up horizontal range	200’ (60m)
carry function range	No limit

Accuracy

reading repeatability	0.1” (2mm) or 0.01” (0.2mm) HP
leveling accuracy	0.1” (2mm) or 0.01” (0.2mm) HP
elevation accuracy	Greater of 0.1” (2mm)/0.01” (0.2mm) HP or 0.2% reading <10’ (3m) & 0.35% reading >10’

Capacity

record capacity	16, 384
record data capacity	137 readings
settings/data retention	Indefinitely, even without battery

Operating Environment

operating temperature range	-22°F to +158°F (-30C to +70C)
storage temperature range	-40°F to +158°F (-40C to +70C)
shock resistance	Measurement Module – 5’ (2m) drop on concrete

Battery

battery type	9V alkaline
battery life	60 hours active use
auto shut-off time	4 minutes inactive