Technidea ZIPLEVEL PRO-2000 User Manual

The MARK function lets you create audible tones: 1) at a selected elevation,
2) for elevations within a selected band, or 3) elevations outside a selected
band. Tones may be set over ZIPLEVEL’s full vertical single setup range.
To set tones, place the Measurement Module at the desired elevation, press
MARK 2 seconds and hold steady until double band lines ash on the dis-
play then press MARK momentarily: 1) without moving the Module for a tone
at the elevation or 2) after moving the Module below for a tone within the
band or 3) after moving the Module above for a tone above the band, beeps
below and silence within. The fraction bar to the right ashes while in the
Mark function.
Press the MARK key 2 seconds to exit – settings will be lost. To exit and re-
tain settings, momentary press ON/OFF while pressing MARK. Press MARK
2 seconds to re-enter.
17 ▪ MARK MARK ▪ 18
Tones can supplement display to level or alarm
at height limits.
STEP 1
DISPLAY
TONES
TONE
AT
MARK
TONE
INSIDE
OF
BAND
TONE
OUTSIDE
OF
BAND
STEP 2
Enter at elevation Set band
Double beep Single beep
USE FOR PRECISE LEVELING
Mark Tone
USE FOR LESS
PRECISE LEVELING
Band
Band
Tone
No Tone
Steady
No Tone
Beeping Tone
FOR ROUGH LEVELLING OR
ELEVATION LIMIT INDICATION
MARK

Technidea ZIPLEVEL PRO-2000 Specifications

Ranges

set-up vertical range	40’ (12m)
set-up horizontal range	200’ (60m)
carry function range	No limit

Accuracy

reading repeatability	0.1” (2mm) or 0.01” (0.2mm) HP
leveling accuracy	0.1” (2mm) or 0.01” (0.2mm) HP
elevation accuracy	Greater of 0.1” (2mm)/0.01” (0.2mm) HP or 0.2% reading <10’ (3m) & 0.35% reading >10’

Capacity

record capacity	16, 384
record data capacity	137 readings
settings/data retention	Indefinitely, even without battery

Operating Environment

operating temperature range	-22°F to +158°F (-30C to +70C)
storage temperature range	-40°F to +158°F (-40C to +70C)
shock resistance	Measurement Module – 5’ (2m) drop on concrete

Battery

battery type	9V alkaline
battery life	60 hours active use
auto shut-off time	4 minutes inactive