Installation / Operation Manual
Troubleshooting
Problem Possible Cause
probe, but are steady during
a steady amount of water.
2. Restricted suction to charge pump on L.A.C.T.
over a period of time (some-
consistent.
-
-
the probe stud to ground for resistance and capaci-
tance readings after removing the detector chasis.
-
-
4728.
No output from 4528 detec-
1. No power or probe wire not attached to probe
stud.
Note:
position and the probe wire is not attached to the
probe.
Recommended Spare Parts
1. 1/2 amp slo-blo fuses p/n 68108327
2. Relay p/n 36017183
3. Detector
0-5% p/n 81001164
0-10% p/n 81001160
0-20% p/n 81001161
0-5% (4-20mA) p/n 81001295
0-20% p/n 81001296
To Next Page
Loading...
