Technogym Skillmill - Page 33

Figure 13
 Iftherechargeismadewithoutdisconnectingthebaeryfromthemachine,thebaerywillturnon
automaticallywhenthebaerychargerisconnectedandthebaerybuonwillbedisabled.When
therechargingprocedurehasended,thebaerywillbeautomaticallyONwhenthebaerycharger
is disconnected.
The baery can also be removed, to charge it in another place without moving the equipment. To
do this:
 Donotpressthebaerybuon.Ifitisaccidentallypressed,theeectwillbeasfollows:
Eect of the baery buon (B):
• if the baery is o, the buon turns it on
• if the baery is on, the buon turns it o
Figure 14
1. Remove the front guard on the equipment and take the baery out of its seat.
2. Disconnect the two connectors that link the baery to the equipment.
3. Connect the power supply unit (connected to the power supply socket) to the baery.
WARNING: use original, approved components.
Skillmill:
Technical Service Guide - Rev. 3.5
Page 33email: support@technogym.com