Technogym Skillmill - Battery (Console Version)

3.1.6 BATTERY (CONSOLE VERSION)
The baery replaces the external power supply to power the various electronic components of the
equipment. The baery charger is the same power supply used for the Connect equipment, and
provides 5V DC and 2.0A max.
The baery is connected to the Low Kit, through which it supplies power to the various equipment
components: the display, angle sensor and RPM sensor.
WARNING: the Skillmill baery MUST NEVER be connected to USB cables other than
the original, approved one on the machine itself. Risk of damage to the baery.
The baery must be recharged every 60 - 90 days, depending on equipment use.
The baery will last 90 days if the equipment is used for 4 hours per day.
When the equipment is delivered, the baery charge level is between 40% and 60%. Before starting
the equipment, completely charge the baery using the specic power supply unit.
To charge the baery, connect the power supply unit to the power supply socket.
Figure 12
 Donotpressthebaerybuon.Ifitisaccidentallypressed,theeectwillbeasfollows:
Eect of the baery buon (B):
• if the baery is o, the buon turns it on
• if the baery is on, the buon turns it o
Skillmill
Technical Service Guide - Rev. 3.5
Page 32
email: support@technogym.com