Technogym Skillmill - 5. MOVING AND INSTALLING THE EQUIPMENT; 5.1 INSTALLATION SPECIFICATIONS AND REQUISITES

5. MOVING AND INSTALLING THE EQUIPMENT
5.1 INSTALLATION SPECIFICATIONS AND REQUISITES
 ATTENTION: refertothe specicmanual,INSTALLATION REQUISITES, whichcanbe
consultedonTechnogymDirect.
1. Place the equipment on aat surface where there are no vibrations and where the load-
bearingcapacityissucientfortheweighttobesupported(takingintoconsiderationthe
weightoftheuseraswell).
2. Dependingonthedestinationcountry,theequipmentmaybeshippedpartiallydismantled,
packedincardboardpackagingandxedtoapalletortotallyassembledinatransparent
plasticwrappingandxedtoawoodenpallet.
For the assembly, refer to the distribution logistics course or the “Skillmill - Assembly instructions”
document contained in the packaging.
3. Theareamustnotbedustyorsandy.
4. Thetemperatureandhumidityoperatingrequisitesindicatedinparagraph“2.3Environmental
characteristics”mustberespected.
Skillmill:
Technical Service Guide - Rev. 3.5
Page43email: support@technogym.com