Technogym Skillmill - 6.3 STRUCTURE FOR ENTERING COMMANDS

6.3 STRUCTURE FOR ENTERING COMMANDS
The structure of the command/message is: @COMANDO [ARG1] [ARG2]#
Character Compulsory Description
@ YES Message start marker
COMMAND YES
Command (the acceptable commands are described in the
following sections)
ARG1 NO First topic of the command (if required by the command)
ARG2 NO Second topic of the command (if required by the command)
#
(hash mark)
YES Message end marker
Table 23
6.3.1 READING FIRMWARE VERSIONS
6.3.1.1 FIRMWARE VERSION (CPU)
Command Notes
Command @FWVER# PrintsthermwareversionintheCPU.
Table 24
6.3.1.2 FIRMWARE VERSION (WI-FI)
Command Notes
Command @WIFIFWVER# PrintsthermwareversionintheWi-Fimodule.
Table 25
The information stored on ASSET will relate to the end part (e.g. CA02.14).
Skillmill
Technical Service Guide - Rev. 3.5
Page 48
email: support@technogym.com