Technogym Skillmill - 7.1 TOOLS; 7.2 DISASSEMBLING THE DISPLAY; 7.3 DISASSEMBLING THE NFC BOARD

7.1 TOOLS
• Medium-sized Phillips screwdriver
• Permanent marker
• Ratchet
• Cuing nippers
• Socket wrench - 8 mm, 10 mm and 17 mm
• Hexagonal adapter, 8 mm
• Pliers
• Hexagonal wrenches: 2.5 mm, 3 mm, 4 mm, 5 mm 6 mm, 8 mm
• Gauge
• Grip pliers
• Pliers for snap ring
• Open-end wrenches: 8 mm, 10 mm, 2 x 13 mm, 17 mm
• Rubber mallet
• Long articulated T-handle wrench, 8 mm
7.2 DISASSEMBLING THE DISPLAY
1. Disconnect the power supply plug.
2. Remove the (interlocked) rear guard from the display.
3. Disconnect the two connectors.
4. Remove the 4 screws that x the rear of the display to the plate.
5. Remove the display.
6. Remove the 2 screws that x the display support guard to the plate.
7. Remove the display support guard.
7.3 DISASSEMBLING THE NFC BOARD
1. Remove the smartphone support on the left-hand side of the equipment, as detailed in the
video “Disassembly instructions - Skillmill” available on the e-learning platform.
2. Disconnect the connector. It is now possible to remove the smartphone support from the
equipment.
3. Remove the 5 screws on the rear of the smartphone support.
4. Remove the NFC board.
Skillmill
Technical Service Guide - Rev. 3.5
Page 98
email: support@technogym.com