TECHNOLOG Cello 6S - Installation: Commissioning - Initial Requirements

C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 14 of 41
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: technolog@technolog.com
www.technolog.com
DMR No.: 7311
2137PM9001 Rev. A
Installation: Commissioning
- initial requirements.
Before starting the process of commissioning your Cello 6S it is to be ensured that the it has been fitted with a SIM card
as per the "Maintenance: SIM card fitting / replacement" section of this manual. It also to be ensured that the computer /
laptop / tablet you are using has the latest release of Technolog "Cello 6 Wizard" software installed (contact Technolog
for details) and that it has been correctly configured.
Refer also to the "Considerations: Installation" section of this manual.
The "Cello 6 Wizard" software is capable of:
Performing live cellular (2G (GSM) / 3G (UMTS)) signal strength tests via the Cello 6.
Configuring the individual channel setup.
Setting the Cello's real-time clock ('RTC').
Programming the meter settings and taking live index readings.
Programming the 'tamper' state.
Setting the index / profile recording parameters.
Setting the dial-out parameters.
Saving all settings to the Cello 6S and sending them to the host server.