C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 3 of 41
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: technolog@technolog.com
www.technolog.com
DMR No.: 7311
2137PM9001 Rev. A
Considerations
Product overview
The 'water' version of Cello 6S is a battery powered, fully integrated, data logger designed primarily for the remote
monitoring, recording and analysis of pulse input data in automatic meter reading ('AMR') applications within water
distribution networks. Data is transmitted remotely over cellular 2G (GSM) and / or 3G (UMTS) mobile
telecommunications networks.
Environment
The Cello 6S 'water' is specifically for use in non-hazardous indoor and outdoor locations, both above and below ground,
in ambient temperatures in the range -20°C to +60°C (or equivalent). Cello 6S, having an ingress protection rating of
IP68 (1m for 48 hours) is suitable for use on sites likely to flood with fresh, un-contaminated, cold water.
Installation
Installation requirements may vary and must be carried out by suitably trained, competent, personnel in accordance with
the applicable code(s) of practice. It is to be ensured that interconnected equipment is suitably rated, both electrically
and mechanically, for use with Cello 6S ' water'.
Approvals
Refer to Technolog Declaration of Conformity ('D of C') document 2137DC9001 associated with the Cello 6S 'water' for
details of applied approvals.
To Next Page
Loading...