TECHNOLOG Cello 6S - Installation: Commissioning - Cello 6 Wizard: Dialout Settings

To Next Page

To Previous Page

Information contained in this document subject to

change without prior notice.

Sheet 30 of 41

Technolog Limited,

Ravenstor Road,

Wirksworth,

DE4 4FY,

United Kingdom

T: +44 (0) 1629 823611

E: technolog@technolog.com

www.technolog.com

DMR No.: 7311

2137PM9001 Rev. A

Installation: Commissioning

- Cello 6 Wizard: Dialout settings - Daily / Weekly / Monthly send

Daily send

- Where the "Send frequency" is set as 'Daily' the Cello 6S will send its data once a day

at the time entered in the "Wakeup time" box.

- The "Gas day start" is the time of day it is required that Cello 6S takes a reading from

the meter(s) to which it is connected. This is normally ignored for non-gas applications

Weekly send

- Where the "Send frequency" is set as 'Weekly' then the day of the week on which the

Cello 6S sends its data is to be selected in the "Send day" drop-down box.

- Where it is required that even though the Cello 6S will only send its data weekly, by

clicking the "Daily Wakeup" box it will wake up and 'listen' for any SMS configuration

messages being sent to it thereby allowing remote, over the air, setup and changes to

be made by the host computer. Where this option is not required then the box is to be

left unticked.

- The time of day at which it is required that Cello 6S will send its data is entered in the

"Wakeup time" box.

Monthly send

- Where the "Send frequency" is set as 'Monthly' then the day of the month on which the