C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 39 of 41
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: technolog@technolog.com
www.technolog.com
DMR No.: 7311
2137PM9001 Rev. A
Installation: Boundary box
Where it is required that the Cello 6S is located in a 'boundary'
type box, the Cello 6S must first be mounted in a suitable
'cradle'. For illustration purposes an Atlantic Plastics (ATPLAS)
"MeterBox" and associated Technolog 2137TT6000 mounting
bracket are shown.
Where it is required that Cello 6S be fitted in another
'boundary' box then there must be a central orifice with a
diameter of not less than 135mm, a depth from the rim of the
orifice to the bottom of the box of not less than 120mm and a
height from the rim of the orifice to the underside of the
boundary box lid of not les than 20mm.
Please contact Technolog where Cello 6S is required to fit in
boundary boxes other than that shown.
Note
Where the Cello 6S does not feature an external antenna
connector, i.e. it only has an internal antenna, then it
should be positioned as high up as possible in the
boundary box and, where practical, away from metal
structures. Ideally before siting the boundary box, in order
to determine the optimal location for Cello 6S remote
communications a signal strength test should be
performed (as detailed in the "Installation: Commissioning
- Cello 6 Wizard: Signal strength" section of this manual)
with the Cello 6S being moved around until the strongest
signal strength is obtained. However be aware that it may
not be physically possible to locate it in the perfect
location.
Refer also to the "Considerations: Installation" and
"Considerations: Environment" sections of this manual.
RF exposure considerations.
For further details please refer to the Technolog
Declaration of Conformity ('D of C') document
2137DC9001 associated with Cello 6S.
Cello 6S secured
in place using M5
screws and self-
locking nuts
To Next Page
Loading...