TECHNOLOG Cello 6S - Page 32

C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 32 of 41
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: technolog@technolog.com
www.technolog.com
DMR No.: 7311
2137PM9001 Rev. A
Sub-daily send (project / application specific)
- Not to be used without first consulting Technolog!
- Where the "Send frequency" is set as 'UK DM Secondary' the Cello 6S sends its data
once per day at 5am.
- Note where this send frequency is selected it automatically:
- Enables the "Daily Wakeup" option to wake up and 'listen' for any SMS configuration
messages being sent to it thereby allowing remote, over the air, setup and changes to
be made by the host computer.
- Sets up the Cello 6S for daylight saving time ('DST') - refer to the "Installation:
Commissioning - Cello 6 Wizard: Setting the time" section of this manual for details.
- Configures the time of day at which Cello 6S takes its readings and sends the data so
the "Wakeup time" and "Gas day start" values cannot be changed.
- Setting the "Send frequency" to 'ProgWakeDefault' should not be used for most
applications. Where set, by default Cello 6S sends its data once per day at 6am.
However this option is programmable by Technolog, either at the factory during
manufacture or remotely once installed, although when programmed its name will
change to whatever has been requested by the customer. Contact Technolog for further
details.
- Be aware that an example of the 'ProgWakeDefault' option for the "Send frequency" is
where the "6hr Prog Wake" option is selected at the initial "Welcome" screen.
- Subsequently at the "Dialout settings" under "Send frequency" there is the new option
'DST 5-11-17-23' which automatically sets up the Cello 6S to take readings from the
meter(s) to which it is connected, and send that data, at 5am, 11am, 5pm and 11pm - be
aware that this method of data send significantly reduces battery life expectancy !
- Note where this send frequency is selected it automatically :
- Enables the "Daily Wakeup" option to wake up and 'listen' for any SMS configuration
messages being sent to it thereby allowing remote, over the air, setup and changes to
be made by the host compuuter.
- Sets up the Cello 6S for daylight saving time ('DST') - refer to the "Installation:
Commissioning - Cello 6 Wizard: Setting the time" section of this manual for details.
- Configures the time of day at which Cello 6S takes its readings and sends the data so
the "Wakeup time" and "Gas day start" values can not be changed.
Installation: Commissioning
- Cello 6 Wizard: Dialout settings - Other send options (continued)