4.2.1.1.4 Privacy Zone
Privacy Zone is for setting some invisible parts in the selected channel, as shown in
Picture4-8 and Picture4-9.
1. Select the number of the zone to be set (maximum 4 zones can be set for single
channel)
2. Click “Setup” to adjust the position of the zone.
3. After finish setting, right click the mouse to return to the “Privacy Zone” page.
4. Click “Save” to save the setting.
Picture4-8 Picture4-9
4.2.1.2 Record
4.2.1.2.1 Record
Go to“Main Menu”→“Record”→“Record” to enter into the interface shown as Picture4-10.
Picture4-10
Channel：
：：
：Set the desired channel in the
drop-down menu
Record：
：：
：Set up the record
status(Enable/Disable) of each channel.
Stream Mode ：
：：
： Select Mainstream or
Substream.
PreRecord ：
：：
： “Enable” status supports
pre-record for motion detection record or
I/O trigger record.
To Next Page
Loading...
