4.2.1.3 Network
4.2.1.3.1 Network
Go to“Main Menu”→“Parameter”→“Network” to enter into the interface shown as Picture
4-13.
Select a kind of network connection (PPPOE, DHCP,Static) and set Port, then user
may remotely control the monitoring, recording, playback or backup of NVR through
network, as shown in Picture 4-13.
Picture 4-13
4.2.1.3.2 E-mail
Go to“Main Menu”→“Parameter”→“Network”→“Email” to enter into the menu interface.
Receive or Send NVR alarm Email and set parameters like Email address, SSL,
Email Enable, Interval and Email Schedule. The related parameter setting should be
consistent with NVR local setting. Refer to Picture 4-14.
Picture 4-14
For PPPoe, Static and DHCP, after setting IP
address of NVR, the extranet port shall be
mapped on the router before visiting NVR
through public network.
Note: Save after setting to make effective. If
there are multiple NVR in a LAN, make sure their
MAC addresses are different (Refer to System).
Take DHCP as an example. In this mode,
the router automatically assigns IP address for
NVR. After restarting NVR or DHCP server,
the IP address obtained by NVR may be
different. As a result, user shall check IP
address and port number for each remote
access of NVR. The operation procedure is as
follows:
1. Select DHCP, click Save and refresh NVR.
Input Client Port and HTTP Port (the two
values must not be the same).
2. Set obtained IP address of NVR and the
mapping port. Refer to section4.2.4.2.
3. Remotely visit NVR by IP address：
http://Public network IP: Web port number
（such as 00080）
http:// Intranet IP: Web port number（such as
00080）（Only available in the same LAN）
To Next Page
Loading...
