Input/Relay mapping tab – allows you to program input and relay mapping
on the NAC. See the “Programming input and relay mapping” section on
page 79.
Note: The Input/Relay mapping tab does not appear if the NAC is in IP
Direct mode, since input and relay mapping does not apply in that IP
Direct mode.
Assigned RAS tab – allows you to assign RASs on the NAC or one of its
buses to the NAC. RASs must be assigned to the NAC and polled before
they can be used. See the “Assigning RASs” section on page 47.
Assigned DGP tab – allows you to assign DGPs on the NAC or one of its
buses to the NAC. DGPs must be assigned to the NAC and polled before
they can be used. See the “Assigning DGPs” section on page 49.
Alarm Control Levels – allows you to control a group of areas when
assigned to a door in Classic Mode. See Alarm Control Levels section on
page 51
Regions- allow you to control regions when assigned to a door in Classic Mode. See
Mode. See
To Next Page
Loading...
