Name: Tecsun PL-368
Brand: Tecsun
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Auto Tuning Storage (ATS)

Automatically tune into and store FM, LW, MW and SW stations

Operation for FM and MW/LW:

1) Quick press [ FM/ST. ] or [ MW/LW ] to select the frequency band.

2) Press and hold the [ FM/ST. ] or [ MW/LW ] button until “PRESET”

flashes and the frequency starts running.

3) When the frequency stops running, it means the ATS operation has

been completed. Rotate the [ TUNING ] knob to view all the stored

stations.

Operation for SW:

There are two ATS modes for SW:

Mode A: Press and hold the [ < ] button to initiate ATS within all meter

bands.

Mode B: Press and hold the [ > ] button to initiate ATS within the selected

meter band.

Tips:

ATS (except in SW mode B) replaces previously stored radio stations.

To prevent this from happening, please consider using ETM+ (see page

14).

ATS results for LW, MW and SW strongly depend on radio wave

propagation conditions, the receiving environment and other factors. If

the results are poor, try to initiate ATS at a different location and/or time,

or tune into stations manually and then store them.

For better ATS results in the LW, MW and SW bands, please also review

the tips for ETM+ on page 16.

Questions and Answers:

Need help?

Do you have a question about the Tecsun PL-368 and is the answer not in the manual?

Tecsun PL-368 Specifications

General