12
Storing Stations During Auto Scan
To avoid any unwanted stations that might be stored during Auto Tuning
Storage (ATS), store stations manually during “Auto Scan” (see also page
9).
1) In VF mode, press and hold the [ VF/VM ] button. The device will auto
scan the entire frequency band for available stations. When a station is
found it will stay there for about 5 seconds before continuing the search.
2) Quick press the memory [ M ] button to store a station, the radio will
keep on scanning for the next available station.
3) To stop the auto scan feature, quick press the [ VF/VM ] button.
Recalling Stored Stations
1) Select the frequency band or mode (SYNC/SSB) of the stored stations
that you wish to view.
2) Quick press the [ VF/VM ] button to enter the VM mode.
3) Rotate the [ TUNING ] knob to view the stored stations. Alternatively,
use the numeric keys to enter the memory location directly. If there is
no stored station at that location, the display shows " — — ".
Memory Scan
The device can auto scan all stored stations within a frequency band or
mode (SYNC/SSB), staying on each station for about 5 seconds before
continuing.
1) Select the frequency band or mode (SYNC/SSB) for which you wish to
view the stored stations.
2) Quick press the [ VF/VM ] button to enter the VM mode.
3) Press and hold the [ VF/VM ] button until “PRESET ” flashes in the
upper right corner of the display. The device starts to scan all stored
stations. Quick press any button (except [ ] (DEL.) to stop scanning.
LISTENING TO STORED STATIONS
To Next Page
Loading...
Need help?
General
