EasyManuals Logo

Tecsun PL-368 User Manual

Tecsun PL-368
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
18
Other Settings and Features
Auto Sorting Memory
This device can automatically organize all stored stations. In power off
mode, press and hold the [ ] (0) button until the station memory preset
indicator on the display starts running. This feature deletes duplicate
stations and sorts the sequence of stored stations from low to high
frequency.
Single Sideband (SSB)
When receiving longwave, medium wave (AM) and shortwave signals, you
can activate the SSB mode to receive particular signals like for example
amateur radio communication and Morse Code, but it can also help to
mitigate interference.
Enable/Disable SSB mode: Quick press [ LSB ] (lower sideband) or
[ USB ] (upper sideband) to enable the sideband. Quick press [ SSB ] to
disable SSB.
Synchronous Detection (SYNC)
When listening to longwave, medium wave (AM) and shortwave
broadcasts, turning on synchronous detection may reduce noise
interference, eliminate distortion caused by local fading during signal
transmission, and suppress interference caused by adjacent stations
(see page 23 for more information).
Enable/Disable SYNC detection:
1) Press and hold [ SYNC ], the display shows “ ” and the
radio enters the synchronous detection mode.
2) Quick press [ LSB ] or [ USB ] to select Lower Sideband or Upper
Sideband SYNC detection.
3) To disable, quick press [ SYNC ] and “ ” disappears.
Note: Enabling the SYNC detector does not always reduce interference.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tecsun PL-368 and is the answer not in the manual?

Tecsun PL-368 Specifications

General IconGeneral
TypePortable Receiver
ModesFM, AM, LW, SW, SSB
FM Frequency Range64 - 108 MHz
LW Frequency Range153-513 kHz
SW Frequency Range1711-29999 kHz
SSBYes
Tuning Steps FM0.01 MHz
Tuning Steps AM1 kHz
Tuning Steps SW1 kHz
Sensitivity AM1 mV/m
Output Power500 mW
SpeakerBuilt-in
Headphone Jack3.5 mm
AntennaTelescopic
Additional FeaturesAlarm, Sleep Timer
Sensitivity FMLess than 3 µV
Power Supply3 x AA batteries or USB power

Related product manuals