Tecsun PL-390 - Listening to Stored Stations; Manual Memory Tuning; Auto Browse Memory Tuning; Direct Memory Address Entry

PL-390 11
LISTENING TO STORED STATIONS
METHOD 1: MANUAL MEMORY TUNING
Press the press [VM] button to
enter the frequency mode, then
rotate the [TUNING] knob to tune
into the stored station one by one.
Memory address
SLEEP
address state
METHOD 2: AUTO BROWSE MEMORY
1. Press the [VM] button with
memory page shows in the
upper right corner to enter
the frequency mode.
2. Press & hold the [VM] button
until “PRESET ” flashing to auto
scan from one memory to
another, staying on each station
for about 5 seconds.
To stop auto search memory,
simply press the [VM] button.
flashing
Auto browse preset station
SLEEP
METHOD 3: DIRECT KEY IN MEMORY ADDRESS
1. Press the [VM] button to enter the memory mode.
2. Press the numeric keys [0] - [9] to enter the memory
address directly, and then press the button to
confirm.
Note: If the display shows “ - - - - ”symbol after entering
the number, it means the entered memory address
does not exist.