flashing
PL-390 15
WORKING WITH ALARM
It is recommended to set the alarm by buzzer if you are not
familiar with the local radio frequency and air time.
SETTING THE ALARM (BY BUZZER)
1. Press & hold the [ ] button
with hour flashing in the upper
right corner, then rotate the
[TUNING] knob to adjust the
hour.
2. Press the [ ] button with
minutes flashing, then rotate
the [TUNING] knob to adjust
the minute.
3. Press the [ ] button with “ “
shows on display to confirm
the setting.
※ If the [ ] button has not been pressed again within 3
seconds, the unit will automatically confirm the alarm
setting.
SETTING THE ALARM (BY RADIO)
First preset the alarm station:
1. Turn on the radio, then tune into your favorite station for
alarm by radio and adjust your desired alarm volume
level.
2. Press the [M] button with “ PRESET ” flashing,
3. Press the [ ] button immediately and notice “ ”
shows on the display to confirm the preset alarm station.
Then set the alarm time:
1. Press & hold the [ ] button with hour flashing in the
upper right corner, then rotate the [TUNING] knob to
adjust the hour.
2. Press the [ ] button with minutes flashing, then rotate
the [TUNING] knob to adjust the minute.
Setting the alarm by buzzer
To Next Page
Loading...
Need help?
General
