TUNE IN STATIONS
Press the [POWER] button to turn on your radio, then
select your desired band by pressing the [FM], [MW/LW]ć
SW[ ] or [ ] button. In case of receiving FM/ SW
broadcasting, fully extend the telescopic antenna for a
better reception. When receiving MW and LW broadcasting,
please rotate the radio or change it's location to achieve
optimum reception. You can rotate the [VOLUME] knob to
adjust to appropriate volume from 0 to 30 levels.
Now, you can turn into your favorite stations with any of the
below tuning methods:
METHOD 1: ETM (EASY TUNING MODE)
ETM is the unique tuning method designed by Tecsun. It
skillfully combines the reception circuitry & control
procedure to pre-select the suspected radio station and
temporarily auto stores them into the ETM memory (not the
regular 550 memories). This highly enhances the efficiency
when tuning into radio stations. Employing ETM to tune
preferred frequencies. you can easily tune into your desired
stations from those preferred frequencies.
flashing
SLEEP
Frequency
changing
Preset station
number ETM
Notes: While operating ETM to search for stations, a few
stations might be missed if there is interference in the
surrounding. In this case, you can simply key-in the
frequency, then press the [ETM] button to manually store it
into ETM memory.
1. Press the [ETM] button with
[ETM] shows on screen to enter
Easy Tuning Mode.
2. Press & hold the [ETM] button until
the frequency start running to
auto scan and store stations into
ETM memory, within the present
band.
3. When the frequency stop running,
turn around the [TUNING] knob to
select those stored stations.
PL-3906
To Next Page
Loading...
Need help?
General
