CAN serial bus configuration menu on page
120
LIN serial bus configuration menu on page 124
FlexRay serial bus configuration menu on page 122
Audio serial bus configuration menu on page 118
USB serial bus configuration menu on page 132
MIL-STD-1553 serial bus menu on page 126
ARINC429 serial bus menu on page 117
See also
Bus Trigger configuration on page 199
Bus Search configuration menus on page 135
Audio serial bus configuration menu
Use the Audio bus menu (optional) to set up and display I2S, Left Justified (LJ), Right Justified (RJ), or TDM Audio serial bus waveforms.
To decode an Audio serial bus:
• To create a new Audio bus waveform, tap the Add Math Ref Bus badge on the Settings bar and select Bus. Double-tap the badge to
open the Bus configuration menu. Set the Bus Type to Audio.
• To change the settings on an existing Audio serial bus waveform, double-tap the Bus waveform badge and make the necessary
changes.
Audio serial bus menu fields and controls
Field or control Description
Display Turns on or off displaying the bus in the Waveform view.
Label Enter a label for the bus. The default label is the selected bus type.
T
o enter label text, double-tap the field and enter label using the virtual keyboard, or tap the field and
enter text from an attached keyboard.
Bus Type Set to Audio.
Audio Type Sets the digital audio signal type. Select from the drop-down list.
Bit Order Set the waveform to decode with most-significant (MS First) bit first or least-significant (LS First) bit
first.
Bit Clock Set the signal source, logic level threshold, and polarity (rising or falling edge) for the Bit Clock signal.
Word Select Set the signal source, logic level threshold, and polarity (normal or inverted) signal setting for the Word
signal.
Data Set the signal source, logic level threshold, and polarity (active high or low) for the Data signal.
Table continued…
Menus and dialog boxes
3 Series Mixed Domain Oscilloscope Printable Help 118
To Next Page
Loading...
Need help?
General
