Tektronix 3 Series User Manual

Note: To trigger on a bus, you must first add the bus to the Waveform view. See Add a math, reference, or bus
waveform on page 71
Note: T
riggering on buses other than Parallel requires the purchase and installation of serial trigger and analysis options. See
the Tektronix Web site for available serial trigger and analysis options.
3. Select the other fields to refine the trigger conditions. The menu fields and trigger graphic update as you make changes to the trigger
settings. Displayed fields depend on the selected trigger type. Selection changes take ef
fect immediately.
4. T
ap the Help icon on the menu title for more information on these settings.
5. Tap outside the menu to close the menu.
Set the acquisition mode
Use this procedure to set the method the instrument uses to acquire and display the signal.
Procedure
1. Double-tap the Acquisition badge on the Settings bar to open the Acquisition configuration menu.
2. Select the acquisition method from the Acquisition Mode list. Set any other parameters associated with the selected acquisition type.
Analog channel operating basics
3 Series Mixed Domain Oscilloscope Printable Help 68

Tektronix 3 Series Specifications

General

Brand	Tektronix
Model	3 Series
Category	Test Equipment
Language	English