Tektronix DSA8200 Series User Manual

Commands Listed in Alphabetical Order
Measurement Se
tup dialog box. (If tracking is enabled for High, the instrument
automatically calculates the high value using the method set with the command,
MEASUrement:MEAS<x>:SOURCE<x>:HILow:METHod.)
NOTE. The SOURCE<x> SOURCE:<<x> argument specifies the
source, which can be source 1 or source 2. To set the actual waveform
(channel, reference, or math) that is assigned to source, you must use the
MEASUremen
t:MEAS<x>:SOURCE<x> WFM command. Two sources are
provided because some measurements (gain, phase) require two sources.
Group
Measurem
ent
Syntax
MEASUrement:MEAS<x>:SOUrc e<x>:HILow:TRACk:HIGH:VALue <NR3
MEASUrement:MEAS<x>:SOUrc e<x>:HILow:TRACk:HIGH:VALue?
Related Commands
MEASUrement:MEAS<x>:SOUrce<x>:HILow:METHod, MEASUrement:
MEAS<x>:SOUrce<x>:HILow : TRACk:HIGH:ENABle
Arguments
NR3 is the absolute value of the high level for the HiLow settings.
Examples
MEASUREMENT:MEAS2:SOURCE1 :HILOW:TRACK:HIGH:VALUE 5 .0E-1 sets
the high value used to take Measurement 2 on the Source 1 waveform to 500 mV.
MEASUREMENT:MEAS1:SOURCE1 :HILOW:TRACK:HIGH:VALUE? might
return
MEASUREMENT:MEAS1:SOURCE1:HI LOW:TRACK:HIGH VALUE
2.00000000000E-001
, indicating that the high value used to take Measurement
3 on the Source 1 waveform is 200 mV.
MEASUrement:MEAS<x>:SOUrce<x>:HILow:TRACk:LOW:ENABle
This command sets or queries whether tracking of the low value for a specified
measurement on a specified source waveform is automatically done by the
instrument. The measurement slot is specified by x, which can be 1 through 8;
the source is specified by x, which can be 1 or 2. Sending this command is
equivalent to specifying a measurement slot (such as Meas 3), selecting a source
(suchasSource1),andthencheckingthecontrol box for Track Low in the in the
HiLow dialog of the Measurement Setup dialog box. (If tracking is enabled, the
instrument automatically calculates the low value using the method set with the
command, MEASUre me nt:MEAS<x>:SOURCE<x>:HILow:METHod.)
2-246 DSA/CSA/TDS8X00/B Series Programmer Manual

Tektronix DSA8200 Series Specifications

General

Brand	Tektronix
Model	DSA8200 Series
Category	Test Equipment
Language	English