To Next Page

To Previous Page

Commands Listed in Alphabetical Order

NOTE. The SOURC

E<x> SOURCE:<<x> argument speciﬁes the

source, which can be source 1 or source 2. To set the actual waveform

(channel, reference, or math) that is assigned to source, you must use the

MEASUrement:MEAS<x>:SOURCE<x> WFM command. Two sources are

provided because some measurements (gain, phase) require two sources.

Group

Measurement

Syntax

MEASUrement:MEAS<x>:SOUrce <x>:HILow:

TRACk:LOW:ENABle { ON

|OFF|NR1}

MEASUrement:MEAS<x>:SOUrce <x>:HILow:TRACk:LOW:ENABle?

Related Commands

MEASUrement:MEAS<x>:SOUrce<x>:HILow:METHod, MEASUrement:

MEAS<x>:SOUrce<x>:HILow:TRACk:HIGH:ENABle

Arguments

ON enables tracking of the low value for the speciﬁed measurement on the

speciﬁed source waveform.

OFF disables tracking of the low value for the speciﬁed measurement on the

speciﬁed source waveform.

NR1 set to 0 disables tracking of the low value for the speciﬁed measurement

on the speciﬁed source wave form; any other value enables tracking of the low

value for the speciﬁed measurement on the speciﬁed source waveform.

Examples

MEASUREMENT:MEAS2:SOURCE1: HILOW:TRACK:LOW:ENABLE ON enables

tracking of the low value used to take Measurement 2 on the Source 1 waveform.

MEASUREMENT:MEAS3:SOURCE2: HILOW:TRACK:LOW:ENABLE? might return

MEASUrement:MEAS3:SOURCE2:HILow:TRACK:LOW:ENABle 0, indicating

that the tracking of the low value for Measurement 3 on the Source 2 waveform is

disabled.

NOTE. A query always returns a 0 or 1.

MEASUrement:MEAS<x>:SOUrce<x>:HILow:TRACk:LOW:VALue

This command sets or queries the low value used to calculate a speciﬁed

measurement on a speciﬁed source waveform. The measurement slot i s speciﬁed

by x, which c an be 1 through 8; the source is speciﬁed by x, which can be 1 or

2. Sending this command is equivalent to selecting a measurement slot (such

as Meas 3), selecting a source (such as Source1), setting tracking Low to off,

and then entering an absolute value in the Low control box in the in the Hi/Low

DSA/CSA/TDS8X00/B Series Programmer Manual 2-247

Tektronix DSA8200 Series User Manual

Questions and Answers: