Commands Listed in Alphabetical Order
Syntax
MEASUrement:M
EAS<x>:UNIts?
Return Values. MEASUrement:MEAS<x>:UNIts? <QString>
"dB" for extinction ratio dB
"Hz" for hertz
"s" for seconds
"unitless" for Q-factor
"V" for volts
"VV" for volts
2
"volt-seconds" for cycle ar ea
"W" for watts (used with optical modules)
"watt-seconds" for cycle area
"%" for percent
"Ω" for ohms (used with TDR)
"Ω -seconds" for cycle area
"ρ" for rho (used with TDR)
"ρ-seconds" for cycle area
Related Commands
MEASUrement:MEAS<x>:VALue?, MEASUrement:MEAS<x>:TYPe
Examples
MEASUREMENT:MEAS3:UNITS? might return MEA SUREMENT:MEAS3:UNITS
"%"
, indicating the units for Measurement 3 are percent.
MEASUrement:MEAS<x>:VALue? (Query Only)
This query only command returns the value that has been calculated for the
measurement slot specified by x.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:VALue ?
Related Commands
MEASUrement:MEAS<x>:TYPe, MEASUrement:MEAS<x>:UNIts?
2-258 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
