Commands Listed in Alphabetical Order
Arguments
Qstring sets th
e label for the incoming waveform.
Examples
WFMINPRE:WFMLABEL "PULSE TEST" sets the label for the incoming waveform
to Pulse Test.
WFMINPRE:WFMLABEL? might return WFMINPRE:WFMLABEL " TEST 4",
indicating that the label for the incoming waveform is set to Test 4.
WFMInpre:XINcr
This command sets or queries the interval between samples of the incoming
waveform.
Group
Waveform Transfer
Syntax
WFMInpre:XINcr <NR3>
WFMInpre:XINcr?
Related Commands
HORizontal:MAIn:RESolution?
Arguments
NR3 is the sampling interval in seconds per p oint.
Examples
WFMINPRE:XINCR 1.0E-9 sets the horizontal sampling interval to 1 ns.
WFMINPRE:XINCR? might return WFMINPRE:XINCR 5.00000000000E-00 9,
indicating that the interval between samples is 5 ns.
WFMInpre:XMUlt
This command sets or que ries the horizontal scale factor (horizontal units per
division) of the incoming waveform.
Group
Waveform Transfer
Syntax
WFMInpre:XMUlt <NR3>
WFMInpre:XMUlt?
Related Commands
HORizontal:MAIn:SCAle
DSA/CSA/TDS8X00/B Series Programmer Manual 2-359
To Next Page
Loading...
Need help?
General
