Commands Listed in Alphabetical Order
Arguments
NR3 is the horiz
ontal scale factor of the incoming waveform.
Examples
WFMINPRE:XMULT 1.0E-5 sets the horizontal scale factor to 10 µs per division.
WFMINPRE:XMULT? might return WFMINPRE:XMULT 1.00000000000E-00 9,
indicating that the horizontal scale factor of the waveform to be transferred is
set to 1 ns per division.
WFMInpre:XOFf
This command sets or queries the horizontal position in horizontal units of the
incoming waveform.
Group
Waveform Transfer
Syntax
WFMInpre:XOFf <NR3>
WFMIn
pre:XOFf?
Related Commands
HORizontal:MAIn:POSition
Arguments
NR3 is the horizon
tal position in horizontal units.
Examples
WFMINPRE:XOFF 6.5E-8 sets the horizontal position for the incoming waveform
to 65 ns.
WFMINPRE:XOFF? might return WFMINPRE:XOFF 2.0E-8, indicating that the
horizontal position for the waveform to be transferred is set to 20 ns.
WFMInpre:XUNit
This command sets or queries the horizontal (x-axis) units of the incoming
waveform.
Group
Waveform Transfer
Syntax
WFMInpre:XUNit <QString>
WFMInpre:XUNit?
Related Commands
HORizontal:UNIts
2-360 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
