Commands Listed in Alphabetical Order
ACQuire:CURR
entcount:HISTHits? (Query Only)
This query only command returns the current count value of histogram hits. The
target value of this c ount is set by the ACQuire:STOPAfter:COUNt command
(in conjunct
ion with the ACQuire:STOPAfter:CONDition c ommand). The
instrument then counts up to this value. When the count reaches (or exceeds) this
value, acquisition stops, and the specified StopAfter action i s enabled.
Group
Acquisition
Syntax
ACQuire:CURRentcount:HIST Hits?
Related Commands
ACQuire:STOPAfter:COUNt, ACQuire:STOPAfter:CONDition
Returns
NR1 is the current count value of histogram hits.
Examples
ACQUIRE:CURRENTCOUNT:HIST HITS? might return
ACQUIRE:CURRENTCOUNT:HIST HITS 100, indicating that currently 100
histogram hits have been acquired.
ACQuire:CURRentcount:HISTWfms? (Query Only)
This query only command returns the current c ount value of waveforms
accumulated for histograms. The target value of this count is set by
the ACQuire:STOPAfter:COUNt command (in conjunction with the
ACQuire:STOPAfter:CONDition command). The instrument then counts up to
this value. When the count reaches (or exceeds) this value, acquisition stops, and
the specified StopAfter action is performed.
Group
Acquisition
Syntax
ACQuire:CURRentcount:HIST Wfms?
Related Commands
ACQuire:STOPAfter:COUNt, ACQuire:STOPAfter:CONDition
Returns
NR1 is the current count value o f histogram waveforms.
2-52 DSA/CSA/TDS8X00/B Series Programmer Manual
To Next Page
Loading...
Need help?
General
