Commands Listed in Alphabetical Order
Examples
ACQUIRE:CURRE
NTCOUNT:HISTWFMS?
might return
ACQUIRE:CURRENTCOUNT:HISTW FMS 25, indicating that currently 25
waveforms have been acquired in the histogram.
ACQuire:CUR
Rentcount:MASKHits<x>? (Query Only)
This query only command returns the current count value of hits in the specified
mask polygon, which can be 1 through 8. The target value of this count is
set by the A
CQuire:STOPAfter:COUNt command (in conjunction with the
ACQuire:STOPAfter:CONDition command). The instrument then counts up to
this value. When the count reaches (or exceeds) this value, acquisition stops, a nd
the specified StopAfter action is enabled.
Group
Acquisition
Syntax
ACQuire:CURRentcount:MASKH its<x>?
Related Commands
ACQuire:STOPAfter:COUNt, ACQuire:STOPAfter:CONDition
Returns
NR1 is the current count value of hits for the specified mask polygon, which can
be 1 through 8.
Examples
ACQUIRE:CURRENTCOUNT:MASKH ITS4 might return
ACQUIRE:CURRENTCOUNT:MASKH ITS4 300, indicating that currently 300 mask
hits have been acquired in mask 4.
ACQuire:CURRentcount:MASKSamples? (Query Only)
This query only command returns the current count value of mask samples. The
target value of this count is set by the ACQuire:STOPAfter:COUNt command
(in conjunction with the ACQuire:STOPAfter:CONDition command). The
instrument then counts up to this value. When the count reache s (or exceeds) this
value, acquisition stops, and the specified StopAfter action is performed.
Group
Acquisition
Syntax
ACQuire:CURRentcount:MASKS amples?
Related Commands
ACQuire:STOPAfter:COUNt, ACQuire:STOPAfter:CONDition
DSA/CSA/TDS8X00/B Series Programmer Manual 2-53
To Next Page
Loading...
Need help?
General
