Tektronix Keithley DMM7510 - Page 42

Section
3: Using a remote interface Model DMM7510 7½ Digit Multimeter
User's Manual
3-16 DMM7510-900-01 Rev. C / September 2019
To set the command set from the front panel:
1. Press the MENU key.
2. Under System, select Settings.
3. Select the appropriate Command Set.
You are prompted to confirm the change to the command set and reboot the instrument.
To verify which command set is selected from a remote interface, send the command:
*LANG?
To change to the SCPI command set from a remote interface, send the command:
*LANG SCPI
Reboot the instrument.
To change to the TSP command set from a remote interface, send the command:
*LANG TSP
Reboot the instrument.