In this section:
Introduction .............................................................................. 9-1
Equipment required .................................................................. 9-1
Device connections .................................................................. 9-2
Integrating with a Model 3706A-S test ..................................... 9-4
Introduction
This application example demonstrates how to configure the DMM7510 and Model 3706A-S System
Switch to interact through TSP-Link
®
. The application measures different types of signals on multiple
channels in multiple slots of a Model 3706A-S.
This is a common production test setup that monitors a variety of signals. These signals are typically
routed through a switch that can accommodate the performance and throughput of the
test requirement.
The example includes:
• 30 channels that measure DC voltage in slot 1 at two different ranges
• 10 channels that measure AC voltage in slot 1
• 20 channels that measure 4-wire resistance in slot 4
Equipment required
This application requires the following equipment:
• One DMM7510
• One Model 3706A-S Six-Slot System Switch
• One Model 3721 Dual 1 x 20 Channel Multiplexer Card and Model 3721-ST Screw
Terminal Block
• One Model 3724 Dual 1 x 30 FET Multiplexer Card and Model 3724-ST Screw Terminal Block
• Multiple devices or components to be tested
• Several insulated banana cables (such as the Model 1756 General Purpose Test Lead Kit that is
provided with the DMM7510)
• One computer set up for communication with the DMM7510
Section 9
Integrating with a Model 3706A-S using TSP-Link
To Next Page
Loading...
Need help?
General
