Commands Listed in Alphabetical Order
Examples
BUS:B1:AUDIO:
BITDELAY 2
sets the bit delay to 2.
BUS:B1:AUDIO:BITDELAY? might return :BUS:B1:AUDIO:BITDELAY 1
indicating th
at the number of delay bits is 1.
BUS:B<x>:AUDio:BITOrder
Specifies the bit order for the AUDIO bus.
Conditions
This command requires the DPO4AUDIO application module for the
MDO4000/B/C series, or the MDO3AUDIO for MDO3000 series.
Group
Bus
Syntax
BUS:B<x>:AUDio:BITOrder {MSB|LSB}
BUS:B<x>:AUDio:BITOrder?
Arguments
MSB specifies that the most significant bit will be expected first in the order.
LSB specifies that the least significant bit will be expected first in the order.
Examples
BUS:B1:AUDIO:BITORDER LSB sets the bit order to LSB.
BUS:B1:AUDIO:BITORDER? might return :BUS:B1:A UDIO:BITORDER MSB
indicating that the MSB is first in the bit order.
BUS:B<x>:AUDio:CHANnel:SIZe
Specifies the number of bits per channel for the AUDIO bus. (To specify the
number of bits per word, use BUS:B<x>:AUDio:DATa:SIZe).
NOTE. This command is applicable only for TDM audio bus type
(
BUS:B<x>AUDio :TYPe TDM
)
Conditions
This command requires the DPO4AUDIO application module for the
MDO4000/B/C series, or the MDO3AUDIO for MDO3000 series.
Group
Bus
2-160 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
