To Next Page

To Previous Page

Commands Listed in Alphabetical Order

BUS:B1:ETHERn

et:SOUrce:DIFFerential?

might return CH2, indicating

that channel 2 is the currently speciﬁed source for Ethernet data differential input.

BUS:B<x>:ETHERnet:SOUrce:DMINus

This command speciﬁes the Ethernet data source for D- input for single-ended

probing. The default is Channel 2.

Conditions

This command requires a DPO4ENET application module for DPO/MSO4000B

and MDO4000/B/C models.

Group

Bus

Syntax

BUS:B<x>:ETHERnet:SOUrce:DMINus {CH1|CH2|CH3|CH 4|D0|D1|D2|D3

|D4|D5|D6|D7|D8|D9|D10|D11|D12|D13|D14 |D15}

BUS:B<x>:ETHERnet:SOUrce:DMINus?

Related Commands

BUS:B<x>:ETH

ERnet:PRObe

BUS:B<x>:ETHERnet:SOUrce:DPLUs

Arguments

CH1–4 speciﬁes to use one of the analog channels as the Ethernet data source

for the D- input.

D0–D15 speciﬁes to use one of the digital channelsD0–D15astheEthernetdata

source for the D- input. (MSO/MDO4000/B/C models only. )

Examples

BUS:B1:ETHERnet:SOUrce:DMINus D5 speciﬁes the Ethernet data source

for the D- input as D5.

BUS:B1:ETHERnet:SOUrce:DMINus? might return CH3, indicating that

channel 3 is the Ethernet data source for the D- input.

BUS:B<x>:ETHERnet:SOUrce:DPLUs

This command speciﬁes the Ethernet data source for the D+ input for single-ended

probing. The default is channel 1.

Conditions

This command requires a DPO4ENET application module for DPO/MSO4000B

and MDO4000/B/C models.

2-176 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Program Manual

Other manuals for Tektronix MDO3000 Series