Commands Listed in Alphabetical Order
Syntax
CONFIGuration
:BUSWAVEFORMS:I2C?
Related Commands
(See page 2-15, Bus Command Group.)
(See page 2-76, Trigger Command Group.)
(See page 2-61, Search Command Group.)
Returns
<NR1> = 1 if the I
2
C bus feature is present.
<NR1> = 0 if the I
2
C bus feature is not present.
CONFIGuration:BUSWAVEFORMS:LIN? (Query Only)
This query returns a boolean value to indica
te whether the optional LIN bus
triggering and analysis feature is present.
Conditions
This feature requires installation of a DPO4AUTO application module, or
MDO3AUTO for MDO3000 models.
Group
Configuration
Syntax
CONFIGuration:BUSWAVEFORMS:LIN?
Related Commands
(See page 2-15, Bus Command Group.)
(See page 2-76, Trigger Command Group.)
(See page 2-61, Search Command Group.)
Returns
<NR1> = 1 if the LIN bus feature is present.
<NR1> = 0 if the LIN bus feature is not present.
CONFIGuration:BUSWAVEFORMS:MIL1553B? (Query Only)
This query returns a boolean value to indicate whether the optional MIL-STD-1553
bus triggering and analysis feature is present.
Conditions
This feature
requires installation of a DPO4AERO application module, or
MDO3AERO for MDO3000 models.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-247
To Next Page
Loading...
Need help?
General
