Commands Listed in Alphabetical Order
Examples
CURSOR:VBARS?
might return the following vertical bar settings
:CURSOR:VBARS:UNITS SECONDS;POSITION1 1.0000E-06;POSITION2
9.0000E-06
CURSor:VBAr
s:ALTERNATE<x>? (Query Only)
Returns the alternate readout for the waveform (Vbar) cursors specified by <x>.
This alternate readout is in effect when the selected waveform is a bus or digital
channel.
Group
Cursor
Syntax
CURSor:VBArs:ALTERNATE<x>?
Arguments
X=1specifies vertical bar cursor1.
X=2specifies vertical bar cursor2.
CURSor:VBArs:DELTa ? (Query Only)
Returns the horizontal difference between the two vertical bar cursors. The units
are specified by the
CURSor:VBArs:UNIts command.
Group
Cursor
Syntax
CURSor:VBArs:DELTa?
Related Commands
CURSor:VBArs:UNIts
Returns
<NR3>
Examples
CURSOR:VBARS:DELTA? might return :CURSOR:VBARS:DELTa 1.0640E+00
indicating that the time between the vertical bar cu
rsors is 1.064 s.
CURSor:VBArs:HPOS<x>? (Query Only)
Returns the vertical value of the specified vertical bar ticks for cursor <x>.
2-262 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual