EasyManuals Logo

Tektronix MDO3000 Series Program Manual

Tektronix MDO3000 Series
1158 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #294 background imageLoading...
Page #294 background image
Commands Listed in Alphabetical Order
CURSor:VBArs:
POSITION1?
this command might return
:CURSOR:VBARS:POSITION1 1.0000E-06 indicating that the
cursor1 vertical bar is positioned at 1 μs.
CURSor:VBArs:UNIts
This command specifies the units for the vertical bar cursors.
Group
Cursor
Syntax
CURSor:VBArs:UNIts {SEConds|HERtz|DEGrees|PERce nt}
CURSor:VBArs:UNIts?
Arguments
SEConds sets the units of the vertical bar cursors for the time domain (seconds).
HERtz sets the units of the vertical bar cursors for the frequency domain (hertz).
DEGrees sets the units to degrees for measuring phase.
PERcent sets the units to percent for use with ratio cursors.
Returns
SECONDS, HERTZ, DEGREES,orPERCENT, depending on the current vertical bar
cursor units.
Examples
CURSOR:VBARS:UNITS HERtz sets the units of the VBArs cursors to 1/seconds.
CURSOR:VBARS:UNITS? might return :CURSOR:VBARS :UNITS SECONDS
indicating that the units for the vertical bar cursor are currently set to seconds.
CURSor:VBArs:USE (No Query Form)
Sets the vertical bar cursor measurement scale.
Conditions
This command is only applicable when ratio cursors are on.
Group
Cursor
Syntax
CURSor:VBArs:USE {CURrent|HALFgrat|FIVEdivs}
Related Commands
CURSor:VBArs:UNIts
2-264 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Table of Contents

Other manuals for Tektronix MDO3000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix MDO3000 Series and is the answer not in the manual?

Tektronix MDO3000 Series Specifications

General IconGeneral
BrandTektronix
ModelMDO3000 Series
CategoryTest Equipment
LanguageEnglish

Related product manuals