Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Group
Cursor
Syntax
CURSor:VBArs:HPOS<x>?
Related Commands
CURSor:VBArs:UNIts
Arguments
<x> specifies the cursor. Valid values are 1 and 2.
Returns
<NR3> is a floating point number that indicates the value of one of the ticks. The
units are the same as the selected waveform.
Examples
CURSor:VBArs:HPOS2? might return CURSOR:VBARS:HPOS2 100E-3,
indicating the waveform value where the cursor intersects it is 0.100.
CURSor:VBArs:POSITION<x>
This command specifies the horizontal position for the specified vertical bar
cursor. The cursor is specified by <x>, which can be 1 or 2. Values are with
respect to trigger position or the zero reference point for the designated waveform
(if horizontal units are not set to time). Use the CURSor:VBArs:UNIts command
to specify units.
Group
Cursor
Syntax
CURSor:VBArs:POSITION<x> <NR3>
CURSor:VBArs:POSITION<x>?
Related Commands
CURSor:VBArs:UNIts
Arguments
<NR3> is a floating point number that specifies the cursor position.
Returns
A floating point value with an exponent.
Examples
CURSor:VBArs:POSITION2 9.00E-6 positions the cursor2 vertical bar cursor
at 9 ms.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-263

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English