Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
DIAg:STATE (N
o Query Form)
This command starts or stops the oscilloscope diagnostic self-tests. Which
self-test is run is specified by the
DIAg:SELect: orDIAg:SELect:<fun ction>
commands.
Group
Calibration and Diagnostic
Syntax
DIAg:STATE {EXECute|ABORt}
Arguments
EXECute starts diagnostics.
ABORt stops diagnostics at the end of the current loop.
Examples
DIAG:STATE EXEC ute starts diagnostics.
DISplay? (Query Only)
Returns the current display settings.
Group
Display
Syntax
DISplay?
DISplay:CLOCk
This command specifies whether the oscilloscope displays the date and time.The
query form of this command returns an ON (1) or an OFF (0).
Group
Display
Syntax
DISplay:CLOCk {ON|OFF|<NR1>}
DISplay:CLOCk?
Related Commands
DATE,
TIMe
2-288 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English