Commands Listed in Alphabetical Order
Examples
MEASUREMENT:M
EAS3:DELAY:DIRECTION BACKWARDS
starts searching from
the end of the waveform record.
MEASUREMENT:
MEAS3:DELAY:DIRECTION?
might return
:MEASUREMENT:MEAS3:DELAY:DIRECTION BACKWARDS indicating
that the current search direction is backwards.
MEASUremen
t:MEAS<x>:DELay:EDGE<x>
This command specifies the slope of the edge used for the delay "from" or "to"
waveform when taking an immediate delay measurement. The waveform is
specified
by MEASUrement:MEAS<x>:SOUrce<x>.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:DELay:EDGE<x> {FALL|RISe}
MEASUrement:MEAS<x>:DELay:EDGE<x>?
Arguments
<x> specifies which waveform to use, where <x> = 1 is the "from" waveform, and
<x> = 2 is the "to" waveform.
FALL specifies the falling edge.
RISe specifies the rising edge.
Examples
MEASUREMENT:MEAS1:DELAY:EDGE1 RISE specifies that the "from" waveform
rising edge be used for the immediate delay measurement.
MEASUREMENT:MEAS1:DELAY:EDGE1? returns either RISE or FALL.
MEASUrement:MEAS<x>:MAXimum? (Query Only)
Returns the maximum value found for this measurement since the last statistical
reset. Measurements are specified by x, which ranges from 1 through 8.
Group
Measurement
Syntax
MEASUrement:MEAS<x>:MAXimum?
Examples
MEASUREMENT:MEAS3:MAXIMUM? might return
:MEASUREMENT:MEAS3:MAXIMUM 4.18E-9.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-435
To Next Page
Loading...
