Commands Listed in Alphabetical Order
Examples
SEARCH:SEARCH
1:TRIGger:A:BUS:B1:ARINC429A:ERRTYPE ANY
sets the
error type to match any of the other available error types.
SEARCH:SEARC
H1:TRIGger:A:BUS:B1:ARINC429A:ERRTYPE?
might return
PARity.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:HIVALue
When the search condition is set to LABel, and the qualifier is set
to either INrange or OUTrange, this command specifies the upper
value of the range for a match on the label field. (Use the command
SEARCH:S
EARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:VALue
to specify the lower value of the range). The default is all X's (don't care).
SEARCH<x> is the search number, which is always 1. B<x> is the bus number.
Conditions
This command requires installation of a DPO4AERO application module for
MDO4000C models, or MDO3AERO for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:HIVALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:HIVALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:QUALifier
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:VALue
Arguments
QString is a quoted string of 8 bits. The allowable characters are 0, 1, and X.
The bits specified in the quoted string replace the least significant bits, leaving
any unspecified upper bits unchanged.
Examples
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:HIVALue
"XXXX1000" sets the upper limit of the range to XXXX1000.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:HIVALue?
might return "XXXXXXXX".
2-616 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
