Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:QUALifier
This command specifies the qualifier to be used when searching on the ARINC429
label field. The search condition must be set to LABel or LABELANDDATA.
The default q
ualifier is "Equal to". SEARCH<x> is the search number, which
is always 1. B<x> is the bus number.
Conditions
This command requires installation of a DPO4AERO application module for
MDO4000C models, or MDO3AERO for MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:
B<x>:ARINC429A:LABel:QUALifier
{LESSthan|MOREthan|Equal|UNEQual|LESSE Qual|MOREEQual|
INrange|OUTrange}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:
QUALifier?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:HIVALue
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ARINC429A:LABel:VALue
Arguments
LESSthan sets label qualifier to less than.
MOREthan sets the label qualifier to greater than.
EQual sets the label qualifier to equal.
UNEQual sets the label qualifier to not equal.
LESSEQual sets the label qualifier to less than or equal.
MOREEQual sets the label qualifier to greater than or equal.
INrange sets the l
abel qualifier to in range.
OUTrange sets the label qualifier to out of range.
NOTE. If the sear
ch condition is set to LABELANDDATA, the label qualifier will
be locked to EQual until the search condition is changed again.
Examples
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:AR INC429A:LABel:QUALifier
LESSthan
sets the label qualifier to less than.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-617

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English