Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
Syntax
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:ETHERnet:IPHeader :
SOUrceaddr:VALue <QString>
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:ETHERnet:IPHea der:
SOUrceaddr:VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:IPHeader:
PROTOcol:VALue
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:IPH:DEST:VAL
Arguments
QString is a quoted string of up to 32 characters where the allowable characters
are 0, 1, and X. The bits specified in the quoted string replace the least significant
bits, leaving any unspecified upper bits unchanged.
Examples
TRIGger:A:BUS:B1:ETHERnet:IPHeader:SOU rceaddr:VALue
“00011001001000010110100000000001”
sets the IP source address to search
for to 192.168.0.1.
TRIGger:A:BUS:B1:ETHERnet:IPHeader:SOU rceaddr:VALue might return
"XXXXXXXXXXXXXXXXXXXXXXXXXXXXXX01".
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER:IPH:DEST:VAL
When the Ethernet search condition is set to IPHeader, this command specifies
the value of the 32–bit destination address that is to be used in the search (along
with the protocol and source address). The IP destination address is a standard IP
address such as 192.168.0.1. The default is all X’s (don’t care).
SEARCH<x> is the
search number, which is always 1, and
B<x> is the bus number 1-4. 1-3 for the
MDO4000C and 1-2 for the MDO3000.
Conditions
This command requires a DPO4ENET application module for DPO/MSO4000B
and MDO4000/B/C models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER :IPH:DEST:VAL
<QString>
SEARCH:SEARCH<x>:TRIG:A:BUS:B<x>:ETHER :IPH:DEST:VAL?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:ETHERnet:CONDition
2-638 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English