Tektronix MDO3000 Series Program Manual

Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:LIN:IDentifier:VALue
This command specifies the binary address string used for LIN search if search
condition is set to
IDentifier or IDANDDATA (identifier and data). SEARC H<x>
is the search
number, which is always 1, and
B<x>
Conditions
This command requires a DPO4AUTO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AUTO application module for
MD
O3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:IDentifier:VALue
<QString>
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LI N:IDentifier:VALue?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:LIN:CONDition
Arguments
<QString> is a quoted string specifying the binary address string to be used
in a LIN search if the search condition is set to
IDentifier or IDANDDATA
(identifier and data).
Examples
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:ID ENTIFIER:VALUE? might
return
SEARCH:SEARCH1:TRIGGER:A:BUS:B1:LIN:IDENT IFIER:VALUE
"XXXXXX"
indicating the binary address is undefined.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:ADDRess:HIVALue
When the MIL-STD-1553 bus search condition is set to COMMAND,andthe
qualifier is set to
INrange or OUTrange , this command specifies the upper
limit of the range for the remote terminal address field. (Use the command
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:
ADDRess:VALue to specify the lower limit of the range.)
SEARCH<x> is the
search number, which is always 1, and
B<x>
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Search
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-671

Tektronix MDO3000 Series Specifications

General

Brand	Tektronix
Model	MDO3000 Series
Category	Test Equipment
Language	English