Commands Listed in Alphabetical Order
SEARCH:SEARCH
<x>:TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:
SUBADdress
SEARCH:SEARC
H<x>:TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:TRBit
Arguments
QString is a quoted string of up to 5 characters, where the allowable characters
are 0, 1 and X.
Examples
SEARCH:SEARCH1:TRIGger:A:BUS:B1:MIL155 3B:COMMAND:COUNt
“01000”
sets the bit pattern for the Word Count/Mode Code field to 01000.
SEARCH:SEARCH1:TRIGger:A:BUS:B1:MIL155 3B:COMMAND:COUNt? might
return “XXXXX”.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MIL1553B:COMMAND:PARity
When the MIL-STD-1553 bus search condition is set to COMMAND, this command
specifies the Command word parity that is to be used in the search.
SEARCH<x>
is the search number, which is always 1, and B<x>
Conditions
This command requires a DPO4AERO application module for DPO/MSO4000B
and MDO4000/B/C models or MDO3AERO application module for
MDO3000 models.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MI L1553B:COMMAND:PARity
{0|1|X|ZERo|ONE|NOCARE|OFF|ON}
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MI L1553B:COMMAND:PARity?
Related Commands
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:MIL1553B:CONDition
Arguments
0
1
X
sets the value to X (“don’t care”) which is the default.
ZERO sets the value to 0.
ONE sets the value to 1.
NOCARE sets the value to X (“don’t care”) which is the default.
MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual 2-675
To Next Page
Loading...
Need help?
General
